Ziyi Li - IEEE Xplore Author Profile

Showing 1-10 of 10 results

Filter Results

Show

Results

Free metal particle can affect surface charge accumulation on epoxy insulator installed in gas-insulated transmission line (GIL) or gas-insulated switchgear (GIS), which results in reduction of surface flashover voltage thus threatening the safe operation of the power equipment. This article reports on the charge accumulation behavior on a real size epoxy insulator with bouncing metal particle und...Show More
Surface charge accumulation on epoxy insulator installed in gas-insulated transmission line (GIL) and gas-insulated switchgear (GIS) has been recognized as a crucial factor for electric field distortion that results in the reduction of surface flashover voltage. This article reports on the gaseous ionization dependence of the charge accumulation pattern on a real-size epoxy insulator with multiarc...Show More
Epoxy insulator widely used in Gas Insulated Switchgear (GIS) and Gas Insulated transmission Line (GIL) is subjected to the risk of surface charge accumulation that leads to the electric field distortion and the reduction in flashover voltage thus threatening the insulation performance. From the viewpoint of safety, it is very necessary to control the charge accumulation on epoxy insulator surface...Show More
Surface charge accumulation on epoxy insulator installed in gas insulated switchgear (GIS) or gas insulated transmission line (GIL) has been recognized as an important factor for electric field distortion that results in reduction of surface flashover voltage. This paper reports on surface charge accumulation behavior on a actual epoxy insulator for 100 kV GIL prototype with multi-arc surface prof...Show More
Surface charge accumulation under DC stress is a critical factor in reducing the insulation performance of epoxy-based nanocomposite. Surface coating has been used to inhibit the charge accumulation, but the inhibition mechanism of the coating material is still unclear. In this paper, graphene oxide (GO) and silicon carbide (SiC) have been selected as fillers to prepare the coating material with e...Show More
Surface charge accumulation on polymer insulating material has been recognized as an important factor for electric field distortion that results in reduction of surface flashover voltage. This paper reports on the charge accumulation behavior between a pair of finger-shaped electrodes on epoxy/Al2O3 nanocomposites under dc voltage superimposed by repetitive pulses. The charge distribution was meas...Show More
Surface charge accumulation on epoxy based nanocomposites under DC stress with and without the presence of a magnetic field was investigated in this work. Two mm-thick sheet samples were prepared by adding 60 nm-Al2O3 particles into epoxy with filler content of 1 to 5 wt%. A pair of finger-shaped electrodes was employed to introduce electric charges onto the sample surface under DC stress of ±5 an...Show More
In this paper, epoxy resin as well as its nanocomposites with Al2O3 as the filler has been employed as the filler has been employed as test sample to investigate the surface charge distribution features before and after DC flashover. Electrical charges were introduced on sample surface by means of a pair of finger-shaped electrodes which were stressed with DC voltage superimposed by repetitive pul...Show More
Epoxy/Al2O3 nanocomposites (EP/Al2O3) have been used as insulating material of electrical equipment. However, charges accumulated on the surface of EP/Al2O3 are regarded as a weakness point that may cause flashover and insulation failure. Accordingly, the understanding of surface charge dynamics is helpful for the safety of the insulation. This paper focuses on the surface charge accumulation char...Show More
This paper mainly investigated the role of surface coating in inhibiting surface charge accumulation and increasing DC flashover voltage on epoxy based nanocomposites. The sample was prepared by incorporating 1 wt% nano Al2O3 particles with epoxy resin (EP), the coating was achieved by mixing uniformly with silicon carbide (SiC) and EP. The effect of coating thickness and SiC content were investig...Show More