Loading [MathJax]/extensions/MathZoom.js
A 16-Channel, 28/39GHz Dual-Polarized 5G FR2 Phased-Array Transceiver IC with a Quad-Stream IF Transceiver Supporting Non-Contiguous Carrier Aggregation up to 1.6GHz BW | IEEE Conference Publication | IEEE Xplore

A 16-Channel, 28/39GHz Dual-Polarized 5G FR2 Phased-Array Transceiver IC with a Quad-Stream IF Transceiver Supporting Non-Contiguous Carrier Aggregation up to 1.6GHz BW


Abstract:

The 5G NR frequency band 2 (FR2) standard has evolved to support mm-wave bands spanning from 24 to 40 GHz. Single-band phased-array beam-forming ICs (BFIC) [1]–[3] for 5G...Show More

Abstract:

The 5G NR frequency band 2 (FR2) standard has evolved to support mm-wave bands spanning from 24 to 40 GHz. Single-band phased-array beam-forming ICs (BFIC) [1]–[3] for 5G have been demonstrated, however, the die size is large. This paper describes a 5G BFIC that supports both N257/N258/N261 (24.25 to 29.5GHz or Low-Band) and N260 (37 to 40GHz or High-Band) FR2 bands, each with 16 antenna ports and concurrent dual polarization for RX/TX, and its corresponding quad-stream intermediate-frequency IC (IFIC), supporting non-contiguous intra-band carrier aggregation (CA) up to 1.6GHz total bandwidth (BW). Figure 27.1.1 shows a 5G mobile phone, where multiple (3 to 4) BFICs, integrated with antenna modules, are placed in parallel and perpendicular to the phone screen for enhanced spherical coverage. BFICs and the antenna module have a skewed aspect ratio to support phone thickness requirement. A power-management IC is integrated on the module, which further reduces area available for the BFIC. However, a traditional BFIC die-size increases in proportion to the number of bands supported, and the IFIC size grows in order to have dedicated signal paths to support multiple BFICs. This paper introduces architecture and circuits techniques to enable area-efficient design of 5G FR2 transceivers.
Date of Conference: 20-26 February 2022
Date Added to IEEE Xplore: 17 March 2022
ISBN Information:

ISSN Information:

Conference Location: San Francisco, CA, USA
References is not available for this document.

The 5G NR frequency band 2 (FR2) standard has evolved to support mm-wave bands spanning from 24 to 40 GHz. Single-band phased-array beam-forming ICs (BFIC) [1]–[3] for 5G have been demonstrated, however, the die size is large. This paper describes a 5G BFIC that supports both N257/N258/N261 (24.25 to 29.5GHz or Low-Band) and N260 (37 to 40GHz or High-Band) FR2 bands, each with 16 antenna ports and concurrent dual polarization for RX/TX, and its corresponding quad-stream intermediate-frequency IC (IFIC), supporting non-contiguous intra-band carrier aggregation (CA) up to 1.6GHz total bandwidth (BW). Figure 27.1.1 shows a 5G mobile phone, where multiple (3 to 4) BFICs, integrated with antenna modules, are placed in parallel and perpendicular to the phone screen for enhanced spherical coverage. BFICs and the antenna module have a skewed aspect ratio to support phone thickness requirement. A power-management IC is integrated on the module, which further reduces area available for the BFIC. However, a traditional BFIC die-size increases in proportion to the number of bands supported, and the IFIC size grows in order to have dedicated signal paths to support multiple BFICs. This paper introduces architecture and circuits techniques to enable area-efficient design of 5G FR2 transceivers.

Select All
1.
B. Sadhu et al., "A 28GHz 32-Element Phased-Array Transceiver IC with Concurrent Dual Polarized Beams and1.4 Degree Beam-Steering Resolution for 5G Communication", ISSCC, pp. 128-129.
2.
J.D. Dunworth et al., "A 28GHz Bulk-CMOS Dual-Polarization Phased-Array Transceiver with 24 Channels for 5GUser and Base-Station Equipment", ISSCC, pp. 70-72, Feb. 2018.
3.
A. G. Roy et al., "A 37–40 GHz Phased Array Front-End with Dual Polarization for 5G MIMO Beamforming Applications", IEEE RFIC, pp. 251-254, 2019.
4.
F. Wang and H. Wang, "An Instantaneously Broadband Ultra-Compact Highly Linear PA with Compensated Distributed-Balun Output Network Achieving > 17.8dBm P1dB and >36.6% PAEP1 dB over 24 to 40GHz and Continuously Supporting 64-/256-QAM 5G NR Signals over 24 to 42GHz", ISSCC, pp. 372-374, 2020.
5.
B. Jann et al., "A 5G Sub-6GHz Zero-IF and mm-Wave IF Transceiver with MIMO and Carrier Aggregation", ISSCC, pp. 352-354, 2019.
6.
H. -C. Park et al., "A 39GHz-Band CMOS 16-Channel Phased-Array Transceiver IC with a Companion Dual-Stream IF Transceiver IC for 5G NR Base-Station Applications", ISSCC, pp. 76-78, 2020.

Contact IEEE to Subscribe

References

References is not available for this document.