Analysis of the Technology of Transfering a Three-Dimensional Model from Cad Format to the Control Code For 3D Printing | IEEE Conference Publication | IEEE Xplore

Analysis of the Technology of Transfering a Three-Dimensional Model from Cad Format to the Control Code For 3D Printing


Abstract:

The paper analyzes the technology for translating a three-dimensional model from a CAD format into a control g-code for subsequent three-dimensional printing. The main st...Show More

Abstract:

The paper analyzes the technology for translating a three-dimensional model from a CAD format into a control g-code for subsequent three-dimensional printing. The main stages of the process are considered, the principles of mathematical modeling at the stages are highlighted, recommendations for possible improvement of the software part of the 3D printing technology are indicated.
Date of Conference: 06-09 October 2020
Date Added to IEEE Xplore: 08 December 2020
ISBN Information:
Conference Location: Vladivostok, Russia

Funding Agency:


I. Introduction

At the moment, 3D printing technology has established itself not only as a means of prototyping, but also as one of the areas of serial industrial production of devices with complex geometry, so more and more enterprises are pursuing a policy of switching production chains to additive manufacturing technologies [1], [2].

References

References is not available for this document.