Processing math: 0%
Kinetic Parameter Measurements in the MINERVE Reactor | IEEE Journals & Magazine | IEEE Xplore

Abstract:

In the framework of an international collaboration, teams of the PSI and CEA research institutes measure the critical decay constant (α0 = β/A), delayed neutron fraction ...Show More

Abstract:

In the framework of an international collaboration, teams of the PSI and CEA research institutes measure the critical decay constant (α0 = β/A), delayed neutron fraction (β) and generation time (A) of the Minerve reactor using the Feynman-α, Power Spectral Density and Rossi-α neutron noise measurement techniques. These measurements contribute to the experimental database of kinetic parameters used to improve nuclear data files and validate modern methods in Monte Carlo codes. Minerve is a zero-power pool reactor composed of a central experimental test lattice surrounded by a large aluminum buffer and four high-enriched driver regions. Measurements are performed in three slightly subcritical configurations (-2 cents to -30 cents) using two high-efficiency 235U fission chambers in the driver regions. Measurement of α0 and β obtained by the two institutes and with the different techniques are consistent for the configurations envisaged. Slight increases of the β values are observed with the subcriticality level. Best estimate values are obtained with the Cross-Power Spectral Density technique at -2 cents, and are worth: β = 716.9±9.0 pcm, α0 = 79.0±0.6 s-1 and A = 90.7±1.4 μs. The kinetic parameters are predicted with MCNP5-v1.6 and TRIPOLI4.9 and the JEFF-3.1/3.1.1 and ENDF/B-VII.1 nuclear data libraries. The predictions for β and α0 overestimate the experimental results by 3-5% and 10-12%, respectively; that for A underestimate the experimental result by 6-7%. The discrepancies are suspected to come from the driven system nature of Minerve and the location of the detectors in the driver regions, which prevent accounting for the full reactor.
Published in: IEEE Transactions on Nuclear Science ( Volume: 64, Issue: 1, January 2017)
Page(s): 724 - 734
Date of Publication: 08 December 2016

ISSN Information:

References is not available for this document.

I. Introduction

Measurement of delayed neutron and generation time in integral experiments, for instance in zero-power research reactors, is of relevance to the nuclear data community and for code validation. Procedures to calculate these kinetic parameters were recently included in Monte-Carlo codes, like MCNP5-v1.6 [1], [2], SERPENT2 [3] and TRIPOLI4.9 [4], and therefore, need to be validated for a wide range of spectral conditions. The International Handbook of Evaluated Criticality Safety Benchmark Experiments database [5] together with several independent experiments (e.g. [6]) are already available for that purpose. Nonetheless, new experiments continue to be performed in zero-power facilities around the world to enlarge the benchmark database and reduce the experimental uncertainties (e.g. [7], [8]). This paper reports on new measurements performed in the Minerve zero-power facility at CEA, Cadarache.

Select All
1.
B. C. Kiedrowski and F. B. Brown, "Adjoint-based k-eigenvalue sensitivity coefficients to nuclear data using continuous-energy Monte Carlo", Nucl. Sci. Eng., vol. 174, pp. 227-244, Jul. 2013.
2.
R. D. Mosteller and B. C. Kiedrowski, "The Rossi alpha validation suite for MCNP", 2011.
3.
J. Leppänen, M. Aufiero, E. Fridman, R. Rachamin and S. van der Marck, "Calculation of effective point kinetics parameters in the serpent 2 Monte Carlo code", Ann. Nucl. Energy, vol. 65, pp. 272-279, Mar. 2014.
4.
A. Zoia, E. Brun and F. Malvagi, "Alpha eigenvalue calculations with tripoli-4", Ann. Nucl. Energy, vol. 63, pp. 276-284, Jan. 2014.
5.
N. N. S. Committee, "International handbook of evaluated criticality safety benchmark experiments", 2013.
6.
A. Santamarina, P. Blaise, L. Erradi and P. Fougeras, " Calculation of LWR beta _{eff} kinetic parameters: Validation on the MISTRAL experimental program ", Ann. Nucl. Energy, vol. 48, pp. 51-59, Oct. 2012.
7.
V. Roland, G. Perret, G. Girardin, P. Frajtag and A. Pautz, "Neutron noise measurement in the CROCUS reactor", Proc. IGORR, 2013.
8.
A. dos Santos, R. Diniz, L. C. C. B. Fanaro, R. Jerez, G. S. de Andrade e Silva and M. Yamaguchi, " A proposal of a benchmark for beta_{eff} beta_{eff}/Lambda and Lambda of thermal reactors fueled with slightly enriched uranium ", Ann. Nucl. Energy, vol. 33, no. 9, pp. 848-855, Jun. 2006.
9.
A. Gruel, P. Leconte, D. Bernard, P. Archier and G. Noguère, "Interpretation of fission product oscillations in the MINERVE reactor from thermal to epithermal spectra", Nucl. Sci. Eng., vol. 169, pp. 229-244, Nov. 2011.
10.
P. Leconte et al., " MAESTRO: An ambitious experimental program for the improvement of nuclear data of structural detection moderating and absorbing materials—First results for nat V 55 Mn 59 Co and 103 Rh ", Proc. ANIMMA, Jun. 2013.
11.
B. Geslot, "Mesure des paramètres cinétiques du réacteur MINERVE par la méthode du bruit de pile—Fiche D’experience", 2014.
12.
"MCS-PCI hardware and software user’s manual".
13.
G. Perret, "Delayed neutron fraction and prompt decay constant measurement in the MINERVE reactor using the PSI instrumentation", Proc. ANIMMA, 2015.
14.
B. Geslot, C. Jammes, G. Nolibe and P. Fougeras, "Multimode acquisition system dedicated to experimental neutronic physics", Proc. IEEE Instrum. Meas. Technol. Conf. (IMTC), vol. 2, pp. 1465-1470, May 2005.
15.
V. Lamirand et al., "Miniature fission chambers calibration in pulse mode: Interlaboratory comparison at the SCKCEN BR1 and CEA CALIBAN reactors", IEEE Trans. Nucl. Sci, vol. 61, no. 4, pp. 2306-2311, Aug. 2014.
16.
B. Geslot, "Pile noise experiment in MINERVE reactor to estimate kinetic parameters using various data processing methods", Proc. ANIMMA, pp. 1-8, Apr. 2015.
17.
C. Berglöf et al., "Auto-correlation and variance-to-mean measurements in a subcritical core obeying multiple alpha-modes", Ann. Nucl. Energy, vol. 38, no. 2, pp. 194-202, Feb. 2011.
18.
J. E. Hoogenboom and A. R. van der Sluijs, "Neutron source strength determination for on-line reactivity measurements", Ann. Nucl. Energy, vol. 15, no. 12, pp. 553-559, 1988.
19.
G. Perret, "Amélioration et développement des méthodes de détermination de la réactivité—Maîtrise des incertitudes associées", 2003.
20.
R. J. Tuttle, "Delayed-neutron data for reactor-physics analysis", Nucl. Sci. Eng., vol. 56, pp. 37-71, Jan. 1975.
21.
R. E. Uhrig, Random Noise Techniques in Nuclear Reactor Systems, New York, NY, USA:Ronald, 1970.
22.
M. M. R. Williams, Random Processes in Nuclear Reactors, Oxford, U.K.:Pergamon Press, 1974.
23.
I. Pázsit and C. Demazière, Noise Techniques in Nuclear Systems, New York, NY, USA:Springer, 2010, [online] Available: https://books.google.ch/books?id=pu9BWuf2gdkC.
24.
E. J. M. Wallerbos and J. E. Hoogenboom, " Experimental investigation of the count-loss effect due to the time interval between counting-gates in the Feynman- alpha method ", Ann. Nucl. Energy, vol. 25, no. 4, pp. 203-208, 1998.
25.
Y. Kitamura, M. Matoba, T. Misawa, H. Unesaki and S. Shiroya, "Reactor noise experiments by using acquisition system for time series data of pulse train", J. Nucl. Sci. Technol., vol. 36, no. 8, pp. 653-660, 1999.
26.
J. P. Lestone, "Energy and isotope dependence of neutron multiplicity distributions", 2005.
27.
D. Babala, "Point-reactor theory of Rossi-alpha experiment", Nucl. Sci. Eng., vol. 28, no. 2, pp. 237-242, 1967.
28.
Y. Yamane, T. Misawa, S. Shiroya and H. Unesaki, " Formulation of data synthesis technique for Feynman- alpha method ", Ann. Nucl. Energy, vol. 25, no. 1, pp. 141-148, 1998.
29.
Y. Kitamura, T. Misawa, H. Unesaki and S. Shiroya, " General formulae for the Feynman- alpha method with the bunching technique ", Ann. Nucl. Energy, vol. 27, no. 13, pp. 1199-1216, Sep. 2000.
30.
J. Fowler, Chi-Square Minimization, 2008, [online] Available: http://web.ipac.caltech.edu/staff/fmasci/home/statistics_refs/Chi-squaremin.pdf.

References

References is not available for this document.