Loading [MathJax]/jax/output/HTML-CSS/autoload/mtable.js
High sensitive and rapid responsive n-type Si: Au sensor for monitoring breath rate | IEEE Conference Publication | IEEE Xplore

High sensitive and rapid responsive n-type Si: Au sensor for monitoring breath rate


Abstract:

125μm- breath sensor with high sensitivity and rapid response was prepared by using n-type Si: Au material. Its sensitivity coefficient and time constant were 4 V.sec/L a...Show More

Abstract:

125μm- breath sensor with high sensitivity and rapid response was prepared by using n-type Si: Au material. Its sensitivity coefficient and time constant were 4 V.sec/L and 38 msec, respectively. Its working principle was based on anomalous resistance effect, which not only increased the sensitivity, but also reduced its time constant greatly. Its signal processing system can select the breath signals and work stably. Therefore, the small changes of breath system can be measured and, especially, patient's breath rate can be monitored at a distance.
Date of Conference: 15-17 April 2011
Date Added to IEEE Xplore: 27 May 2011
ISBN Information:
Conference Location: Wuhan
No metrics found for this document.

1. Introduction

For semiconductors containing shallow impurities, including n-type silicon, the variation of its resistance with temperature obeys . R_{s}=C\Gamma^{3/2}\eqno{\hbox{(1)}}

where C is proportional constant. For single crystal n-type silicon doped with deep impurities, near room temperature, the relationship between its resistance and temperature T satisfies[1]–[3] R_{d}=C\ exp[-(E_{F^{-}}E_{A})/kT]\eqno{\hbox{(2)}}
where k is Boltzmann constant, Fermi level and the deep acceptor level in the band gap of silicon containing deep acceptor impurities. For n-type Si:Au, the anomalous resistance effect of exponential term in Eq.(2) can increase the sensitivity greatly. To compare the effects of and , we take \eqalignno{&\left\vert {{dR_{d}}\over{dR_{s}}} \right\vert =\left\vert{{dR_{d}/dT}\over{dR _{s}/dT}}\right\vert=2T^{1/2}(E_{F}-E_{{\rm A}})B(T) &{\hbox{(3)}}\cr &B(T)=\exp [-(E_{F}-E_{A})/kT]/3k}
Fermi level and the deep acceptor level of gold impurity are equal to 0.57 eV and 0.54 eV, respectively, below the conduction band in the band gap of our n-type Si:Au material and, thus, . At room temperature , we have \Bigl\vert {{dR_{d}}\over{dR_{s}}} \Bigr\vert =1.3 \times 10^{3} \eqno{\hbox{(4)}}
Our experimental measuring value iS . Therefore, the sensitivity of -breath sensor, made by Wheatstone bridge using n-type Si:Au material as bridge arms, can be increased by times, comparing with containing shallow impurities [4].

Usage
Select a Year
2025

View as

Total usage sinceJun 2011:78
00.20.40.60.811.2JanFebMarAprMayJunJulAugSepOctNovDec100000000000
Year Total:1
Data is updated monthly. Usage includes PDF downloads and HTML views.
Contact IEEE to Subscribe

References

References is not available for this document.