Loading [MathJax]/extensions/MathMenu.js
High-Bandwidth Graded-Index Plastic Optical Fiber With Low-Attenuation, High-Bending Ability, and High-Thermal Stability for Home-Networks | IEEE Journals & Magazine | IEEE Xplore

High-Bandwidth Graded-Index Plastic Optical Fiber With Low-Attenuation, High-Bending Ability, and High-Thermal Stability for Home-Networks


Abstract:

The graded-index plastic optical fiber (GI-POF) is expected to be a communication medium for the next-generation optical home network because of its simple-to-use connect...Show More

Abstract:

The graded-index plastic optical fiber (GI-POF) is expected to be a communication medium for the next-generation optical home network because of its simple-to-use connection, installation, and high bandwidth. In spite of the expectation, we had a problem that a typical GI-POF using poly (methyl methacrylate) (PMMA) had high transmission loss in the expected communication wavelength band (VCSEL: 670-680 nm) for home networks; the required values of being below 200 dB/km could not be achieved. We, therefore, propose poly (2, 2, 2-trichloroethyl methacrylate) (PTCEMA) as a base material for the GI-POF. A PTCEMA-based GI-POF was fabricated, and its characteristics were evaluated. The PTCEMA is a prominent material in terms of its transparency and heat-resistant property. Our results demonstrated that the fabricated fiber surpassed the desired characteristics for the home network pertaining to attenuation and heat resistance. Specifically, the attenuation in the wavelength band (670-680 nm) was 104-136 dB/km, and the glass transition temperature (Tg) was 102°C in the core center where the Tg was at its lowest. Moreover, we confirmed that our PTCEMA-based GI-POF had sufficient mechanical strength and low bending loss. These results indicate that our novel GI-POF can be a candidate for home networks.
Published in: Journal of Lightwave Technology ( Volume: 29, Issue: 11, June 2011)
Page(s): 1620 - 1626
Date of Publication: 05 April 2011

ISSN Information:

References is not available for this document.

I. Introduction

Today, a number of services, which include large information contents like high-definition movies, is rapidly growing. Single-mode glass optical fiber (SMF) has been utilized in trunk lines, becoming the indispensable information transmission medium in the form of large information pipelines connecting large cities and nations. However, the core diameter of the SMF is very small (10 m), and an extremely precise technique is required for connecting the fibers to signal-receiving devices. For this reason, it would be difficult to install the SMF for optical home networks.

Select All
1.
K. Koike and M. Asai, "The future of plastic optical fiber", NPG Asia Mat., vol. 1, pp. 22-28, 2009.
2.
Y. Koike, "High-bandwidth grade-indexpolymer optical fibre", Polymer, vol. 32, pp. 1737-1745, 1991.
3.
C. Tanaka, K. Kurashima, M. Naritomi, A. Kondo and Y. Koike, "The first-loss and high-bandwidth 61-127 channel graded-indexsteric cores polymer waveguide", Proc. OFC/IOOC, 2008.
4.
S. Randel, Proc. Eur. Conf. Optical Commun., 2006.
5.
F. Breyer, S. C. J. Lee, S. Randel and N. Hanik, "1.25 Gbit/s transmission over up to 100m standard 1 mm step-index polymer optical fibre using FFE or DFE Equalisationschemes", Proc. Eur. Conf. Optical Commun. 9.6.6, 2007.
6.
J. Lee, F. Breyer, S. Randel, H. van den Boom and T. Koonen, "Gigabit ethernet over standard step-indexpolymer optical fiber", Proc. Int. POF Conf., vol. 17, 2008.
7.
F. Breyer, S. C. J. Lee, S. Randel and N. Hanik, "PAM-4 signalling for gigabit transmissionover standard step-index plastic optical fibre using light emitting diodes", Proc. ECOC, 2008.
8.
Y. Koike, T. Ishigure and E. Nihei, "High-bandwidth graded-index polymer opticalfiber", J. Lightw. Technol., vol. 37, no. 7, pp. 1475-1489, Jul. 1995.
9.
B. Boutevin, A. Rousseau and D. Bosc, "Accessible new acrylic monomers and polymersas highly transparent organic materials", J. Polym. Sci. Part A: Polymer Chemistry, vol. 30, pp. 1279-1286, 1992.
10.
K. Koike, M. Fratisek, Y. Koike and Y. Okamoto, "Design and Synthesis of Graded Index PlasticOptical Fibers by Copolymeric System", Polymers for Advanced Technol., vol. 19, pp. 516-520, 2008.
11.
K. Koike, M. Fratisek, Y. Okamoto and Y. Koike, "Design synthesis and characterization ofa partially-chlorinated acrylic copolymer for low-loss and thermally-stablegraded index plastic optical fibers", J. Polym. Sci. Part A: Polymer Chemistry, vol. 47, pp. 3352-3361, 2009.
12.
T. Ishigure, E. Nihei and Y. Koike, "Optimum refractive-index profile of the graded-index polymeroptical fiber toward gigabit data links", Appl. Opt., vol. 35, pp. 2048-2053, 1996.
13.
J. W. Fleming, " Material and mode dispersionin GeO \$_2 -B \$_2 O \$_3 -SiO \$_2 ", J. Amer. Cer. Soc., vol. 59, pp. 503-507, 1976.
14.
R. Olshansky and D. B. Keck, "Pulse broadening in graded-indexoptical fibers", Appl. Opt., vol. 15, pp. 483-491, 1976.
15.
M. Asai, R. Hirose, A. Kondo and Y. Koike, "High-bandwidth graded-index plastic optical fiber by thedopant diffusion coextrusion process", J. Lightwave Technol., vol. 25, no. 10, pp. 3062-3067, Oct. 2007.
16.
F. M. E. Sladen, D. N. Payne and M. J. Adams, "Determination of optical fiberrefractive index profiles by a near-field scanning technique", Appl. Phys. Lett., vol. 28, pp. 255-258, 1976.
17.
K. I. White, "Practical application of therefracted near-field technique for the measurement of optical fibre refractiveindex profiles", Opt. Quantum Elect., vol. 11, pp. 185-196, 1979.
18.
T. Ishigure, M. Hirai, M. Sato and Y. Koike, "Graded-index plastic optical fiber with high mechanicalproperties enabling easy network installations", J. Appl. Poym. Sci., vol. 91, pp. 404-409, 2004.

Contact IEEE to Subscribe

References

References is not available for this document.