Loading [MathJax]/extensions/MathMenu.js
Fuse and load testing with mid-sized, high energy density flux compression generators | IEEE Conference Publication | IEEE Xplore

Fuse and load testing with mid-sized, high energy density flux compression generators


Abstract:

Compact Pulsed Power Systems (CPPSs) require power sources that are small in size yet can produce the necessary electrical energy required to drive a given load. Helical ...Show More

Abstract:

Compact Pulsed Power Systems (CPPSs) require power sources that are small in size yet can produce the necessary electrical energy required to drive a given load. Helical Flux Compression Generators (HFCGs) are attractive for single shot applications due to their rapid conversion of chemical energy to electrical energy. Mid-sized generators occupy little total volume (∼4,000-cm3 total with a compressible volume of ∼300-cm3 in the present generator design), while the high explosives used in an HFCG provide an energy density of ∼8,000 MJ/m3. Consistent output current and energy gain from shot to shot are key variables in the ability of an HFCG to drive CPPSs effectively. An investigation into the practicality of using mid-sized HFCGs as the driver for single shot CPPSs is presented. Data and waveforms from generators fired into 3 μH inductive loads are shown, with results measuring the generator’s performance as a driver for an inductive energy storage (IES) system. Results are also shown from adding a power conditioning system to the output of the HFCG, where the measurements demonstrate the ability of an HFCG to drive high impedance loads. The effectiveness of a mid-sized HFCG as drivers for these systems will be evaluated.
Date of Conference: 17 June 2008 - 22 June 2007
Date Added to IEEE Xplore: 14 October 2008
ISBN Information:

ISSN Information:

Conference Location: Albuquerque, NM, USA
No metrics found for this document.

I. Introduction

HFCGs have been used as high current/high magnetic field sources since the 1950’ s. Systems powered solely by an HFCG can be limited by several factors. One factor is that small to mid-sized generators have been known to suffer from inconsistent output for successive shots [1]. One solution for this problem is to employ a construction technique which minimizes deviations in the generator characteristic parameters from one generator to the next. An HFCG design, fabrication technique and initial performance measure were outlined in [2] and [3], with the aim of increasing long term generator consistency. This paper provides more analysis on the consistency of generator performance for successive shots.

Usage
Select a Year
2025

View as

Total usage sinceJan 2011:110
00.511.522.53JanFebMarAprMayJunJulAugSepOctNovDec020000000000
Year Total:2
Data is updated monthly. Usage includes PDF downloads and HTML views.
Contact IEEE to Subscribe

References

References is not available for this document.