Path Planning using a Dynamic Vehicle Model | IEEE Conference Publication | IEEE Xplore

Path Planning using a Dynamic Vehicle Model


Abstract:

This paper addresses the problem of path planning using a dynamic vehicle model. Previous works which include a basic kinematic model generate paths that are only realist...Show More

Abstract:

This paper addresses the problem of path planning using a dynamic vehicle model. Previous works which include a basic kinematic model generate paths that are only realistic at very low speed. By considering higher vehicle speed during navigation, the vehicle can significantly deviate from the planned trajectory. Consequently, the planned path becomes unusable for the mission achievement. So, to bridge a gap between planning and navigation, we propose a realistic path planner based on a dynamic vehicle model
Date of Conference: 24-28 April 2006
Date Added to IEEE Xplore: 16 October 2006
Print ISBN:0-7803-9521-2
Conference Location: Damascus, Syria
References is not available for this document.

1 Introduction

Moving an autonomous vehicle is often divided in two phases. In the first one, a feasible path between two configurations is computed. Then, this path is followed by the vehicle, using the trajectory returned by the planner and a control law. Most of research works considered these two steps as independent and only focus on one of them. Unfortunately, the planning phase is strictly dependent on the model used during the navigation process.

Select All
1.
J. P. Laumond, S. Sekhavat and F. Lamiraux, Robot Motion Plannirng and Control. J.-P. Lau-mond, Guidelines in nonholonomic motion planning for mobile robots, 1998.
2.
L. E. Kavraki, P. Svestka, J. C. Latombe and M. Overmars, "Probabilistic roadmaps for path planning in high-dimensional configuration spaces", International Trans. Robotics and Automation, vol. 12, no. 4, pp. 566-580, June 1996.
3.
E. Mazer, J. M. Ahuactzin and P. Bessiere, "The ariadnes clew algorithm", Journal of ArtificialIntelligence Research, vol. 9, pp. 295-316, November 1998.
4.
B. Bouilly, T. Simeon and R. Alami, "A numerical technique for planning motion strategies of a mobile robot in presence of uncertainty", Proc. IEEE International Conference on Robotics and Automation, pp. 1327-1332, 1995.
5.
T. Fraichard and R. Mermond, "Path planning with uncertainty for car-like robots", Proc. IEEE International Conference on Robotics and Automation, pp. 27-32, 1998.
6.
A. Lambert and D. Gruyer, "Safe path planning in an uncertain-configuration space", IEEE International Conference on Robotics and Automation, pp. 4185-4190, May 2003.
7.
A. Lambert and N. L. Fort-Piat, "Safe task planning integrating uncertainties and local map federation", International Journal of robotics Research, vol. 19, no. 6, pp. 587-611, 2000.
8.
L. E. Dubins, "On curves of minimal length with a constraint on average curvature and with prescribed and terminal position tangents", AmericanJ. of Math., no. 79, pp. 497-516, 1957.
9.
S. Taheri, "An investigation and design of slip control braking systems integrated with four wheel steering", 1990.
10.
S. M. LaValle, "Rapidly-exploring random trees: A new tool for path planning", Computer Science Dept., November 1998.
11.
S. M. LaValle, J. J. Kuffner, B. R. Donald, K. M. Lynch and D. Rus, "Algorithmic and Computational Robotics: New Directions", ch. Rapidly-exploring random trees: Progress and prospects, pp. 293-308, 2001.
12.
J. J. Kuffner and S. M. LaValle, "Rrt-connect: An efficient approach to single-query path planning", IEEE International Conference on Robotics and Automation (ICRA ‘2000), pp. 995-1001, 2000.
13.
H. B. Pacejka and J. M. Besselink, "Magic formula tyre model with transient properties", International Colloquium on Tyre Models for Vehicle Dynamric Analysis, pp. 234-249, 1997.
14.
J. Dugoff, P. Fanches and L. Segel, "An analysis of tire traction properties and their influence on vehicle dynamic performance", SAE, 1970.
Contact IEEE to Subscribe

References

References is not available for this document.