Abstract:
A dual-band vertical polarization omnidirectional antenna is proposed with the same three substrates in a low profile. The design is configured with four horizontal layer...Show MoreMetadata
Abstract:
A dual-band vertical polarization omnidirectional antenna is proposed with the same three substrates in a low profile. The design is configured with four horizontal layers, a wheel-shaped patch (Patch 1) with an outer loop strip on the upper of the top printed circuit board (PCB) (Sub1), a fan-shaped patch (Patch 2) on the top of the mid PCB (Sub2), a four-sector patch on the upper of the bottom PCB (Sub3), and a ground with a ring slot on the lower of Sub3. The four vertical layers are a central coaxial probe from Sub3 to Patches 1 and 2, four inner posts from Patch 1 to Patch 2, four mid posts from the ground to Sub1, and four outer posts from the ground to Patch 1. Based on the new structure, five resonant modes in the passband and one stopband are produced for omnidirectional radiation with vertical polarization. The measured results demonstrate that the impedance bandwidths are 1.62–2.8 GHz (53.4%) and 3.18–4.3 GHz (30%). Therefore, the dual-band operation with a profile as low as 0.053λL (λL is the wavelength at the lowest frequency of operation) makes the proposed antenna suitable for indoor mobile communications in the bands of DCS1800/PCS1900/UMTS2000/LTE2300 /LTE2500 and 5G NR n77.
Published in: IEEE Antennas and Wireless Propagation Letters ( Volume: 22, Issue: 12, December 2023)
Funding Agency:
School of Physics and Optoelectronic Engineering, Guangdong University of Technology, Guangzhou, China
School of Physics and Optoelectronic Engineering, Guangdong University of Technology, Guangzhou, China
School of Physics and Optoelectronic Engineering, Guangdong University of Technology, Guangzhou, China
School of Physics and Optoelectronic Engineering and the State Key Laboratory of Precision Electronic Manufacturing Technology and Equipment, School of Electromechanical Engineering, Guangdong University of Technology, Guangzhou, China
School of Physics and Optoelectronic Engineering and the State Key Laboratory of Precision Electronic Manufacturing Technology and Equipment, School of Electromechanical Engineering, Guangdong University of Technology, Guangzhou, China
State Key Laboratory of Precision Electronic Manufacturing Technology and Equipment, School of Electromechanical Engineering, Guangdong University of Technology, Guangzhou, China
Contents School of Physics and Optoelectronic Engineering, Guangdong University of Technology, Guangzhou, China
School of Physics and Optoelectronic Engineering, Guangdong University of Technology, Guangzhou, China
School of Physics and Optoelectronic Engineering, Guangdong University of Technology, Guangzhou, China
School of Physics and Optoelectronic Engineering and the State Key Laboratory of Precision Electronic Manufacturing Technology and Equipment, School of Electromechanical Engineering, Guangdong University of Technology, Guangzhou, China
School of Physics and Optoelectronic Engineering and the State Key Laboratory of Precision Electronic Manufacturing Technology and Equipment, School of Electromechanical Engineering, Guangdong University of Technology, Guangzhou, China
State Key Laboratory of Precision Electronic Manufacturing Technology and Equipment, School of Electromechanical Engineering, Guangdong University of Technology, Guangzhou, China
