Test Whats new message.
Scheduled Maintenance on Monday 1/13/2025
Single article sales and account management will be unavailable from 5:00 AM - 7:00 PM ET (09:00 - 23:00 UTC). We apologize for the inconvenience.
Showing 1-7 of 7 results
- Sort
Sort By
Results
Application of Optoelectronic Technique for Detection of Air Corona, Surface Discharges at Cable Termination and End winding of Stator Coil
Dillip Kumar Puhan;Rajat Sharma;R. Kandiban;Burjupati Nageshwar Rao
2019 IEEE 4th International Conference on Condition Assessment Techniques in Electrical Systems (CATCON)
Year: 2019 | Conference Paper |
Cited by: Papers (1)
Partial discharge in high voltage equipment like generators, motors, transformers, power cables etc. occur due to various manufacturing defect sites or due to aging of the insulation under various stresses. Occurrence of surface discharges at the termination of cables, end winding of stator bars, surface discharges along the supporting insulators in case of gas insulated systems are common. Prolon...Show More
Influence of Metal oxide and Metalloid Nano Particles on the Dielectric Response of HVDC Cable Nano Dielectric
2019 IEEE Electrical Insulation Conference (EIC)
Year: 2019 | Conference Paper |
Influence of nano fillers like MgO, SiO2 and clay on the dielectric response of HVDC cable dielectric is investigated. Surface treated metal oxide MgO, metalloid SiO2nanoparticles and nano clay of different concentrations in low density polyethylene was considered for the study. LDPE-nano dielectric was prepared by using Brabender twin screw extruder and thin samples were obtained using hot plate ...Show More
Low Density Polyethylene - Clay Nano Dielectric prepared by Melt Extrusion Process: Dielectric and Thermal properties
Nageshwar Rao Burjupati;R Kandiban;R.K Anju;Parthasarathy Ashwin
2019 2nd International Conference on Electrical Materials and Power Equipment (ICEMPE)
Year: 2019 | Conference Paper |
LDPE Nano clay dielectric has been investigated as fillers in low density polyethylene in concentrations of 1 phr to 4 phr (1gm in 100gm). LDPE- clay melt compound was pressed under a plate vulcanizer at 140 °C for 10 minutes to produce film samples of 100 micron and 200 micron. The distribution and dispersion of the nano particles in the LDPE is determined by SEM (Scanning Electron Microscopy). E...Show More
Characterization of LDPE-Metal Oxide Nanocomposites Using Thermo-Analytical and Spectroscopic Techniques
2018 IEEE 2nd International Conference on Dielectrics (ICD)
Year: 2018 | Conference Paper |
Polyethylene metal oxide nanocomposites find their application as high voltage insulation for direct current cables, to mitigate the space charge and other issues. Nano particles like SiO2, MgO, ZnO etc are used as filler materials in polyethylene matrix to achieve good electrical and mechanical properties like: space charge reduction, enhanced surface & volume resistivity and higher dielectric st...Show More
Extraction of mole from eye sclera using object area detection algorithm
2016 International Conference on Wireless Communications, Signal Processing and Networking (WiSPNET)
Year: 2016 | Conference Paper |
Cited by: Papers (5)
Moles are used for identifying a person and can be located on any part of the human body. Mole growth may cause melanoma and cancer. Early detection and growth can help to avoid cancer and loss of visibility. The proposed algorithm is used for detecting moles in the human eye sclera. An eye mole image is the input image for the proposed algorithm. This input image is preprocessed using gray-scale ...Show More
An intelligent speed controller for Brushless DC motor
2012 7th IEEE Conference on Industrial Electronics and Applications (ICIEA)
Year: 2012 | Conference Paper |
Cited by: Papers (14)
Brushless DC (BLDC) motors are widely used for many industrial applications because of their high efficiency, high torque and low volume. This paper proposed a improved Fuzzy PID controller to control speed of Brushless DC motor. The proposed controller is called proportional-integral-derivative (PID) controller and Fuzzy proportional-integral-derivative controller. This paper provides an overview...Show More
Design of Fuzzy PID controller for Brushless DC motor
2012 International Conference on Computer Communication and Informatics
Year: 2012 | Conference Paper |
Cited by: Papers (57)
Brushless DC (BLDC) motors are widely used for many industrial applications because of their high efficiency, high torque and low volume. This paper proposed a improved Fuzzy PID controller to control speed of Brushless DC motor. The proposed controller is called proportional-integral-derivative (PID) controller and Fuzzy proportional-integral-derivative controller. This paper provides an overview...Show More
IEEE Account
Purchase Details
Profile Information
Need Help?
- US & Canada: +1 800 678 4333
- Worldwide: +1 732 981 0060
- Contact & Support
- About IEEE Xplore
- Contact Us
- Help
- Accessibility
- Terms of Use
- Nondiscrimination Policy
- Sitemap
- Privacy & Opting Out of Cookies
A not-for-profit organization, IEEE is the world's largest technical professional organization dedicated to advancing technology for the benefit of humanity.
© Copyright 2025 IEEE - All rights reserved. Use of this web site signifies your agreement to the terms and conditions.