A Case for Micromachines in Laboratory-Based DFIG Wind Turbine Systems for Fault Studies

For laboratory-based systems, the selection of components is critical to ensure proper representation of the actual system. In past investigations, researchers made use of small-scale off-the-shelf wound rotor induction machines (WRIMs) to perform laboratory-based studies. However, there are no reports validating their applicability in comparison to using the actual machines. In this regard, this paper investigates the correlation between the dimensional parameters and the electrical asymmetry indicators for a large-scale wind generator and laboratory-based generators. For the latter, a comparison is made between using a standard small-scale off-the-shelf WRIM and a micromachine. It is shown that the harmonic frequencies in a healthy machine and those due to inherent asymmetries appear at the same positions on the stator current spectrum for the three machines. However, there is a difference in the amplitudes of these components, given their dependence on the winding factors for a specific machine. The dimensional analysis techniques used to scale down the large-scale generator into a micromachine ensure that these parameters are related. However, this is not the case for the standard small-scale WRIM. Further work demonstrates the correlation of the fault-related harmonics between the micromachine and the large-scale machine for a rotor inter-turn fault condition. Micromachines are designed to ensure that the time constants are proportional representations of the larger machine, thus providing an accurate reflection of what is expected under transient operating conditions of wind turbines. This would assist in the development of condition monitoring strategies that are suited for the actual systems in the industry.