Multirate Finite-Control-Set Model Predictive Control for High Switching Frequency Power Converters

Due to the modulator free structure, the finite-control-setmodel predictive control (FCS-MPC) needs a high sampling frequency/interrupt frequency (20–50 kHz) for power converters application, while the typical converter switching frequency is around 20–25% of the sampling frequency. To obtain a high switching frequency, it is not always practical to increase the sampling rate by considering the computational burden in a digital processor. Therefore, increasing the switching frequency without using a high sampling frequency is a critical task for FCS-MPC, particularly applied to silicon carbide and gallium nitride-based high switching frequency power converters. To solve this problem, this article proposes the multirate FCS-MPC (MRFCS-MPC), where the control frequency is allowed to be higher than the sampling frequency. Consequently, the switching frequency can be significantly increased without changing the sampling frequency. The proposed scheme inherits the ability to handle complex control objectives from the traditional FCS-MPC. The lifting model is built to predict the fast rate information of state variables based on the low sampling output. Then, the fast rate control inputs within one sampling interval are solved efficiently with a good tradeoff between computational burden and optimized system performance. The experimental motor drive system tests are carried out to verify the effectiveness of the proposed MRFCS-MPC.