A Frequency Translation System for Multi-Channel, Multi-Nuclear MR Spectroscopy

Objective: Most MRI scanners are equipped to receive signals from
¹
H array coils but few support multi-channel reception for other nuclei. Using receive arrays can provide significant SNR benefits, usually exploited to enable accelerated imaging, but the extension of these arrays to non-
¹
H nuclei has received less attention because of the relative lack of broadband array receivers. Non-
¹
H nuclei often have low sensitivity and stand to benefit greatly from the increase in SNR that arrays can provide. This paper presents a cost-effective approach for adapting standard
¹
H multi-channel array receivers for use with other nuclei - in this case,
¹³
C. Methods: A frequency translation system has been developed that uses active mixers residing at the magnet bore to convert the received signal from a non-
¹
H array to the
¹
H frequency for reception by the host system receiver. Results: This system has been demonstrated at 4.7T and 7T while preserving SNR and isolation.
¹
H decoupling, particularly important for
¹³
C detection, can be straightforwardly accommodated. Conclusion: Frequency translation can convert
¹
H-only multi-channel receivers for use with other nuclei while maintaining SNR and channel isolation while still enabling
¹
H decoupling. Significance: This work allows existing multi-channel MRI receivers to be adapted to receive signals from nuclei other than
¹
H, allowing for the use of receive arrays for in vivo multi-nuclear NMR.