Capacitive Power Tapping From Insulated Shield Wire of Overhead High Voltage Transmission Lines With Tuning

Due to a lack of high and stable power supplies for large-scale online monitoring devices, the intelligent development of high voltage transmission lines has always been restricted. This paper presents a method for capacitive power tapping from an insulated shield wire of overhead high voltage transmission lines with tuning. A general equivalent model, which considers the influence of line sag and landform on the equivalent circuit parameters, is established. The calculated equivalent circuit parameters show good agreement with the field measured data obtained by a 220 kV single-circuit transmission line. In order to maximize the tap-off power, a nonlinear tuning method is proposed since linear tuning can cause an overvoltage problem, and a tuned reactor is developed. Based on the measured equivalent circuit parameters, an experiment platform is built in the laboratory to measure the tap-off power under different resistive loads. The experimental results indicate that the maximum power is about 900 W, which represents an improvement of 80% compared with the maximum power without tuning. Additionally, the tuned reactor shows good robustness to the perturbation of equivalent circuit parameters, which validates the effectiveness of the proposed power tapping method.