Comparison of Distinct Discharge Modes for Ozone Production in a Novel DBD Configuration With Three Flat Electrodes

In this paper, a new configuration of dielectric-barrier discharge (DBD) reactor with three electrodes was manufactured and used to produce ozone. Designed flatly, this reactor is capable of establishing three different discharge modes from type of the volume and surface discharges, without modifying its internal structure. The aim of presenting this paper is to experimentally analyze the three discharge modes and their combination using a second channel to produce ozone. The two reactor channels are identical in terms of dimensions, material, and manufacturing process. Two frequency-adjustable pulse generators of the same electrical characteristics and two high-voltage transformers were used in the course of the experiments. The applied sinusoidal voltage is from 0 to 12 kVp-p. The frequency range was determined and fixed for all three discharge modes for the highest ozone concentration at a fluctuation rate of 1 L/min. Effects of increasing the applied voltage on the obtained concentration from the three different discharge modes were experimentally analyzed. Using the provided inlets-outlets, the effect of flowing gas through the length and width of the discharge area on ozone concentration was investigated, and appropriate flow directions were determined for the flowing gas under either of the three discharge modes. Experimentally results have been done for this three discharge modes as well as hybrid modes. The maximum ozone production rate achieved up to 14.52 g/h in the series combination of two different volume discharge. At 96% oxygen purity, ozone production yield, in two modes volume discharge VaDBD and surface discharge SDBD, have been improved up to 529.87 g/kWh. However, the total input power of the entire system is 120.2 W.