Parametric Amplification in Depletion Layer Transduced Microelectromechanical Resonator

This paper introduces a method for signal amplification and enhancement of full width half maxima (FWHM) in a depletion layer-transduced flexural resonator using the parametric effect. The device can be used as a filter-amplifier, or as a low-noise readout method for sensors. Parametric excitation shows a significant drop in device impedance, from 334.2 k
$\Omega $
without a pump signal to 45.9 k
$\Omega $
with a 300 mV pump signal. In the absence of the pump signal, with an input power of
$-$
10 dBm, the resonator produces an output power of
$-$
44.87 dBm at
$\sim$
400 kHz and a FWHM value of 23 Hz. However, when a 200 mV pump signal at 2
$f_{0}$
with
$\pi $
/2 phase shift, is superimposed with the same input power, the resonator’s output power amplifies to
$-$
11.49 dBm, and the FWHM value substantially decreases to 10 Hz. This leads to a 33.58 dBm of amplification and 2.3x improvement in Q attributed to the parametric effect. A detailed analytical model of the transducer is presented.2024-0061