Evaluation of wetting condition and its effects on pollution flashover voltage of aerodynamic insulators

The flashover performance of insulators is significantly affected by the degrees and ways of wetting the pollution layer. However, there have only been a few reports on the wetting condition and its effects on the flashover characteristics of pollution on insulators to date. In this paper, a phase-angle difference-based method is proposed to test the wetting conditions of the pollution layer on insulators. A corresponding measuring device is also developed. The wetting process of the pollution layer on aerodynamic-type glass insulators is studied in an artificial climate chamber using the developed device. The related flashover performance is studied via the even-rising voltage method. Test results show that the phase-angle difference (PAD) curve accurately reflects the entire wetting process of the pollution layer from the initial stage, through the saturated stage to the oversaturated and washing away stages. Over the wetting process, the PAD curve initially drops sharply, and then remains stable for a few minutes before eventually rising slowly to the initial value. The PAD curve has its lowest value when the pollution layer is wetted to saturation, which occurs after approximately 5 min in our experiments. The flashover voltage characteristics of insulators are also significantly affected by the wetting conditions of the pollution layer. The flashover voltage in the saturated stage is shown to be lower than that in the other stages. Therefore, to improve the accuracy of the artificial pollution tests, quantitative methods (including PAD) should be used to obtain the exact time of wetting to saturation.