Investigation of the impact of opto-mechanical parameters towards high speed manufacturing of 3-dimensional patterns with nanosecond laser

Laser-based subtractive manufacturing absorbs enormous attention in the manufacturing of the most advanced materials. The technique has a wide range of applications in biomedicine, photonics and semiconductors and aerospace [1]. Using this technology enhances precision, machining speed, and quality consistency compared to conventional methods. A pulsed laser with high-repetition-rate scans the desired coordinates to offer high-speed manufacturing [1]. However, the machined area has uniform depth (i.e. 2-dimensional micromachining) since the power density does not exceed the ablation threshold out of the focal plane.In order to machine a 3D pattern, we must alter the depth of machining. The variation of machining depth could be achieved by either moving the sample in Z direction or varying the opto-mechanical parameters. Regardless of the approaches, it is essential to quantify the impact of the opto-mechanical parameters. For this purpose, we developed the setup (figure 1) which includes a pulsed laser (wavelength: 532 nm, pulse duration <; 20ns), XY galvo mirror systems and l50 mm converging lens. To obtain a high speed of machining, we decided to move the laser beam by using galvo mirror systems. We developed an algorithm in MATLAB to control the galvo for the laser beam delivery into the desired coordinates. In the current study, we conducted 3 sets of experiments to investigate the effects of the opto-mechanical parameters on Magnesium. In the first set of experiments, we studied the impacts of the pulse overlap (0, 40 and 80 %) and the laser power (1.1 and 2.4 w) on machining depth. For the second set of experiments, we kept the overlap to 80% and varied the number of pulses from 50 to 400 for 1.1 and 2.4 w laser power. For the last set of experiments, we utilized the image-based approach [1], [2] to machine the 2D complex pattern (figure 2 (b)) by applying the best combination of optical parameters. After machining, the specimens were scanned by the interferometer (WYKO NT110) to measure the depth and roughness of the samples. The results depict the growth of laser power (from 1.1 to 2.4 w) significantly increases the depth of the machined zone from 4 to 24 μm. We observed increasing the pulse overlap from 0 to 80 % drops the surface roughness. Increasing the number of pulses in specific XY coordinates from 50 to 400 could rise the depth by 4 times (figure 2 (a)). In this study, we realized machined depths could be varied by changing the laser power, pulse overlap, and the number of pulses. We also developed a way to machine a 2D/3D complex pattern with minimum achievable roughness. This approach can be an effective step toward the subtractive manufacturing of 3D-constructs.