A Modified Interleaved Capacitor Clamped DC–DC Converter With Non-Resonant Soft Switching

Since the solar panels and fuel cells have low output voltage, which need to be converted to the 400 V or higher dc bus voltage in the renewable energy power generation systems, where, the high gain dc–dc converter plays a key role. Furthermore, with the requirement of the converter in low cost and high efficiency, the soft-switching interleaved boost-type converters based on switched-capacitor and voltage multiplier cell as the high gain dc–dc converters have been widely applied. However, the above-mentioned soft-switching interleaved boost-type converters in literature have resonant spikes on the switches or there are coupled inductors, which will cause the high cost due to the large stresses of the switches or low efficiency due to the high core losses of the coupled inductors. To solve the above-mentioned problems, a modified interleaved capacitor clamped (MICC) dc–dc converter with non-resonant soft-switching (NRSS) is proposed, in which only an auxiliary inductor operating in discontinuous conduction mode with few μH is used to achieve the zero-current-switching for all switches and diodes. Furthermore, the operating principle of the proposed converter is given, the interleaved boost structure is used as the front stage of the proposed converter to reduce the input current ripple and lighten the current stress on all switches and magnetic components, the MICC structure with NRSS as the output stage is proposed as a voltage multiplier module to achieve the high voltage gain. Then, the circuit parameter design for this converter is presented. Finally, a 400 W experimental prototype is built to verify the correctness and the effectiveness of the proposed topology.