Correction of Time-Varying Baseline Errors Based on Multibaseline Airborne Interferometric Data Without High-Precision DEMs

The time-varying baseline error (TVBE) caused by the residual motion errors is one of the most significant error sources in the airborne interferometric synthetic aperture radar (InSAR). Although global digital elevation model (DEM) products can be used to extract the TVBE for areas without high-precision DEMs, they cause remarkable height differences (HDs) relative to the actual InSAR-measured topography. In addition, due to the low flight height of airborne SAR platforms, the range-dependent phases resulted from the HDs have significant impacts on the TVBE estimation. Through the mutual restraint of multibaseline observations, this research establishes a multibaseline parameterized model jointly considering HDs and TVBEs in each range direction for the absolute phase calibration. A weighted truncated singular value decomposition (TSVD) algorithm is used to solve the ill-posed problem in joint parameter estimation. Note that, to improve the TVBE extraction, a two-step strategy is adopted. In step one, TVBEs and HDs are preliminarily estimated by the multibaseline parameterized model. After that, bare areas with flat topography, where the truths of HDs can be assumed to be 0, are selected to correct the bias of the estimated HDs. If the flat and bare areas are absent, global ecosystem dynamics investigation (GEDI) or Ice, Cloud, and land Elevation Satellite (ICESAT) points can be used instead. In step two, the multibaseline parameterized model is updated by the calibrated DEM and then used to reestimate the TVBEs. The proposed method was validated by using a simulated data set and two real data sets (i.e., the P- and L-band data sets acquired by the airborne E-SAR system during the BioSAR2008 campaign). The results show that, with respect to the reference values, the root-mean-square error (RMSE) of the calibrated DEMs is 0.48 m for the simulated data set, 2.6 m for the P-band data set, and 3.6 m for the L-band data set, suggesting that the high-precision DEMs are well reconstructed and the TVBE-induced phases can be precisely extracted. After correcting the TVBE-induced phases, the accuracy of the DEMs generated by every linked phase (LP) is improved by at least 38.2% for P-band and by at least 51.0% for L-band. To assess the effectiveness and practicability of the proposed model, we further investigated the influence of the limited multibaseline number, and the baseline combination, and the precision of external DEMs on the TVBE correction. In conclusion, without high-precision DEMs, the multibaseline parameterized method can work well in accurately extracting the TVBE, even for the limited airborne InSAR data set.