An Improved Industrial Analysis of Electrical Equipment using Deep Learning based Approach

In general some if the modern electrical equipments are used to tighten and loosen screws. Its ends should be slightly flattened to fit into the grooves at the top of the screw. It is available in 4″, 6″, 8″, 9″ and 12″ lengths. We name it according to its length. Its handle is made of wood or plastic. Plastic handles look attractive but do not last as long as wooden handles. Its handle is made of plastic. Used for tightening and loosening small screws in connectors, bearings, fuses, etc. Maximum length is 4″ or 5″. It is the most important tool for electrical workers. It will be at the level of connecting The handle is made of plastic. It is arranged in the form of an inductance cylinder with a resistor, a neon lamp and a coil connected in series. A plug (Clip) on the probe head with a resistor, neon lamp, coil arc and wire are connected in series with each other. Place this probe on a point where there is current and if you put your finger on the plug on the probe head, the neon lamp in the middle will light up. We know that if the light is not lit then there is no current in the point.