HW-CVD deposited μc-Si:H for the inverted heterojunction solar cell

P-type-microcrystalline-silicon/n-type-crystalline-silicon hetero-junction solar cell has been prepared by means of hot-wire chemical vapor deposition (HW-CVD) technique. The solar cell structure was illuminated on the opposite side of the normally-formed heterojunction. With this inverted structure, the photovoltaic cell has the design potential to improve the light-incident surface-texturing with the possibility to avoid the use of transparent conducting oxide (TCO). Solar cells were fabricated on Czochralsky (CZ)-grown phosphorous-doped crystalline-silicon (c-Si) substrates within 0.5 to 1 ohm-cm. HW-CVD has employed for the deposition of a very thin intrinsic hydrogenated amorphous silicon (i-a-Si) as a buffer-layer as a heterojunction interface, and boron-doped hydrogenated microcrystalline silicon (p-μc-Si) on c-Si substrate. The tungsten catalyst temperature (T
_fil
) was settled to 1600°C and 1950°C for i-a-Si and p-μc-Si films, respectively. Silane (SiH
₄
), hydrogen (H
₂
) and diluted diborane (B
₂
H
₆
) gases were used for p-μc-Si at the substrate temperatures (T
_sub
) of 200°C. The obtained I-V characteristics under simulated solar radiation at 100mW/cm
²
are: Jsc =26.1 mA/cm
²
; Voc = 545 mV; Jm = 21.4 mA/cm
²
; Vm = 410 mV; FF = 61.7%, with total area efficiency of η = 8.8%. The solar cell has great potential to improve its conversion efficiency with proper surface passivation and antireflection coat.